简介General Description
此液压动力单元**为登车桥设计,由高齿轮油泵、直流电机、多用集成块、各式液压阀、油箱等零部件有机组合为一体。主甲板上升到位后,唇板自动上升,主甲板和唇板的下降由电磁阀实现,主甲板和唇板的下降速度由节流阀调节,使下降速度在**的范围内。
This power unit is desig** exclusively for the dock leveler,consisting of high pressure gear pump, DC motor, multi-functional manifold,va**es and tank.etc.After the main platform is fuily lifted, lip rises automatically.The both lowering movements are activated by the solenoid va**es with speed adusted by the throttles.
外型尺寸Outline Dimension 系统工作原理Hydraulic Circuit Dia**
型号规格说明Model Specifi**ions
型号 Model |
电机电压 Motor Volt |
电机功率 Motor power |
油泵排量 Displacement |
溢流阀压力 System pressure |
油箱容量 Tank Capacity |
L (mm) |
|
RBZ-E2.1B4E10/1 |
380VAC |
0.75KW |
2.1mL/r |
16MPa |
3.5L |
508 |
|
RBZ-E2.7B4E10/1 |
380VAC |
0.75KW |
2.7mL/r |
14MPa |
5L |
558 |
|
说明:
1.如需不同流量的泵、压力、电机功率等系统参数,请查看液压动力单元型号说明。
1.Please go to page 1 or consult our sales engineer for the different pump displacement,motor power or tank capacity.
2.如需手动应急放油装置,请在订货时说明。
2.The manual override function is **ailable on request.
注意事项Special Notes
1.此动力单元不可连续运转,(1分钟ON,9分钟OFF)可重复工作。
1.The power unit is of S3 duty,which can only be worked intermittentiy,ie.,1 minute on and 9 minutes off.
2.安装前必须**油缸、油管、接头等液压元件清洁无任何杂质粘附。
2.Clean all the hydraulic parts concemed before mounting the power unit.
3.液压油粘度应为15-68CST,应清洁无杂质,推荐使用N46号液压油。
3.The viscosity of the oil shoud be 15-68 cst.
4.系统使用个100小时后,应更换液压油,以后每3000小时更换一次液压油。
4.Change the oil after the first 100 hours of using the power unit,then change the oil every 3000 hours.
5.**启动运行系统时,应立即检查油箱中的油量是否充足。
5.Check the oil level in the tank after the first star of the power unit.